winaa
Member

196 Likes

Page 13 of 14 First 1234567891011121314 Last

• Jump to page:

1. 
   R93 liked post by winaa On thread : 260 Rem, AI & Imp

   Ran the above load through Quickload with a 2.950" OAL came back as 2913 FPS from a 27" barrel Max Pressure 65968 PSI, Saami spec is 60191 PSI He must have a strong action and good brass

   Liked On: 29-10-2018, 03:58 PM

2. 
   Stocky liked post by winaa On thread : Speed estimation.

   If you give me your OAL and your fired case capacity in GR's water I put hem though quickload. I put it through at 2.8in and quickloads std case capacity of 53.25gr water and get 2751fps that is...

   Liked On: 28-10-2018, 08:43 PM

3. 
   rewa liked post by winaa On thread : barrel length v velocity 6.5 Creedmoor

   another youtube link https://www.youtube.com/watch?v=b32w6CWWn2U&list=WL&index=35&t=0s

   Liked On: 04-10-2018, 03:56 PM

4. 
   stevodog liked post by winaa On thread : 2206H or 2208 for 7mm08 ?

   For a 16inch barrel and 120Gr projectiles I would use 2206H, heavier use 2208

   Liked On: 27-09-2018, 07:48 AM

5. 
   Steve123 liked post by winaa On thread : "HELP" T3 with shocking grouping ???????

   First Question when did you free float the barrel? If it was shooting fine before you free floated it, then this will be you problem, you will have to either Stabilize the forend of the stock and...

   Liked On: 26-09-2018, 04:53 PM

6. 
   diana2 liked post by winaa On thread : 7mm08 case capacity

   Yip sure does In My rifle (7mm08) here are some fired case capacity's in grains water Federal 55.67 Gr Norma 55.73 Gr Hornady 56.25 Gr Remington 56.65 Gr Winchester 57.4 Gr As you can see...

   Liked On: 22-08-2018, 05:56 PM

7. 
   PERRISCICABA liked post by winaa On thread : How hard do you typically push your loads?

   I start about the middle and work up until I find a load with the lowest SD with safe pressure, then adjust seating depth to get good accuracy. Job done. Generally this ends up 0.5 to 1 grain...

   Liked On: 04-08-2018, 06:50 PM

8. 
   Moa Hunter liked post by winaa On thread : How hard do you typically push your loads?

   I start about the middle and work up until I find a load with the lowest SD with safe pressure, then adjust seating depth to get good accuracy. Job done. Generally this ends up 0.5 to 1 grain...

   Liked On: 04-08-2018, 03:02 AM

9. 
   Hayden C liked post by winaa On thread : 7mm 150 ELD X in 7mm 08

   here's some more info for you, Remember that the 150 ELD-X is 0.156-inch longer than the SMK that ADI list so you will need to increase your OAL to get near their max charge's 91657 91658

   Liked On: 24-07-2018, 09:07 AM

10. 
    PERRISCICABA liked post by winaa On thread : Where to get a little gong?

    Pretty easy for a local engineering firm to fabricate one up for you if you don't have the diy skills. The disk just needs to be high tensile like 4140 or biz80 plate. For the up rights 1/2inch...

    Liked On: 12-04-2018, 08:10 AM

11. 
    MB liked post by winaa On thread : Where to get a little gong?

    Pretty easy for a local engineering firm to fabricate one up for you if you don't have the diy skills. The disk just needs to be high tensile like 4140 or biz80 plate. For the up rights 1/2inch...

    Liked On: 11-04-2018, 09:58 AM

12. 
    HuntGatherRepeat liked post by winaa On thread : Published vs actual load variations.

    The chronograph will be out I had exactly the same problem with it, I used Applied ballistics (with a custom curve) to do a Ballistic Calibration and the speed given from the Chrony was 105fps too...

    Liked On: 18-10-2017, 06:05 PM

13. 
    rossi.45 liked post by winaa On thread : .243 Varminting

    70gr Speer TNT, work up a charge with ADI-2208. I had mine shooting just under 2inch groups at 300m using this combo that's around .6MOA. Add a suppressor and barrel jump is greatly reduced and...

    Liked On: 09-08-2017, 02:47 PM

14. 
    kiwijames liked post by winaa On thread : 7mm08 rechamber

    284Win is about all you can do. here's a link for some info Short Action .284 Win for Hunting and Tactical (http://www.6mmbr.com/gunweek095.html). 7mm08 will get you out to 600m on animals with...

    Liked On: 09-08-2017, 07:46 AM

15. 
    Beaker liked post by winaa On thread : NZ Shooting Ranges - map and contacts

    Added rotorua Deerstalkers also Bkackpowder and pistol club on either side

    Liked On: 06-11-2016, 09:28 AM

Page 13 of 14 First 1234567891011121314 Last

• Jump to page: