Thread: 243 loads

Originally Posted by chubby

Im thinking just size the brass so 4 - 5 mm of the neck is sized back to factory , ul get less resistance n the projectile will press in2 the case rather than the barrell , but also use a case without a primer n should take away the hassell of removing the firing pin ( BUT i am no expert n have done this only once )

Sent from my SM-G930F using Tapatalk

I just neck size the fired case completely then run a slice down the centre of the neck with a thin hack saw blade. It holds enough pressure to keep the projectile seated once you find the lands but no chance of it getting stuck in the rifling. The I adjust the die ever so slightly so it's just off the lands.