Thread: A little suppressor H&S

Originally Posted by Philipo

I see Larskramer was asking about suppressor threads and it reminded me to post this up, this will be common knowledge to some but was a surprise to me & luckily it didn't end up in a disaster ( I've had a suppressor pop on me in the past and wasn't pleasant )

I own six Dpt's and have had a great run with all of em, so this is a "general suppresor thing" I'm not directing any anti towards their products.

One piece of advice l would say to people is with all the Can's l own being very similar in appearance, double check every time you go to fit or run different coluored tape on each one.

I can't post a vid at the mo for some fuktard reason ( & haven't used youtube for yonks) so here's a quick run down - Was at the range for a load development & sighting in session, multiple rifles and unknown to myself someone had picked up one on my cans ( I normally un-screw after a string of shot's to cool down, as ya do ) & my 22 ( 5/8 x 24 ) was next to the 6.5 cm rifle ( threaded 15 x 1 ) both look very similar and l wasn't paying full attention ( to busy talking az usual ) it rattled slightly but screwed on tight, fired a shot which surprisingly didn't hit the target, like wtf , then l realize my problem, luckily Dpt's are slightly over bored and a 6.5 will fit down the hole, no damage to suppressor, rifle or operator.

So just something to be weary of, to many this is probably common knowledge but I'm not an engineer, l am aware of over threading but funny how easily and tight it locked on, let's call this a "friendly Philipo advice" : )


Two rifles involved

Sako Black wolf 6.5 Creedmoor - threaded 15 x 1
Tikka CTR 223 - 5/8 x 24

Attachment 207497

Attachment 207498

Thanks for the post @Philipo I found it informative as you intended I have been wondering about this very topic having a barrel with 14x1 thread and another 5/8 x 24, wondering how close they were.

Also thanks to @DPT for an engineers for giving a professional report