Pommy
Member

1184 Likes

Page 11 of 79 First 1234567891011121314151617181920212223242561 ... Last

• Jump to page:

1. 
   zimmer liked post by Pommy On thread : Keen to start reloading.

   The cheap ones are not a suitable replacement for a decent balance beam scale imo, as they tend to drift a fair bit.

   Liked On: 15-10-2023, 08:25 AM

2. 
   19Badger liked post by Pommy On thread : Keen to start reloading.

   The cheap ones are not a suitable replacement for a decent balance beam scale imo, as they tend to drift a fair bit.

   Liked On: 14-10-2023, 06:14 PM

3. 
   m101a1 liked post by Pommy On thread : Keen to start reloading.

   The cheap ones are not a suitable replacement for a decent balance beam scale imo, as they tend to drift a fair bit.

   Liked On: 14-10-2023, 04:35 PM

4. 
   dannyb liked post by Pommy On thread : Keen to start reloading.

   The cheap ones are not a suitable replacement for a decent balance beam scale imo, as they tend to drift a fair bit.

   Liked On: 14-10-2023, 04:15 PM

5. 
   drunk_mexican liked post by Pommy On thread : BA13 load development

   How hot you can comfortably load is down to how strong the action is and how tough the brass and primers are. It's all part of a system containing a small explosion. If you use a thin primer that...

   Liked On: 29-09-2023, 02:44 PM

6. 
   Bowhunta liked post by Pommy On thread : Should I avoid Hornady brass?

   It's poor quality brass vs the likes of Norma and Nosler. Which would be fine if Hornady ammo didn't cost just as much.

   Liked On: 11-09-2023, 01:46 PM

7. 
   fluffchucker liked post by Pommy On thread : Bipod, uphill shooting issue.

   We could speculate all day over why you're missing. Have you been able to spot any of your misses? Did you cock up and get a bad range reading? Was your turret a full turn off? Etc... Would really...

   Liked On: 08-09-2023, 04:19 PM

8. 
   11mms liked post by Pommy On thread : Tikka 7mm rem mag -OAL

   Really depends on the wear on your barrel. I would be unsurprised if it had at least 0.1" of jump but you'll have to measure it to know. The 20 thou jump people often try to start at is fairly...

   Liked On: 07-09-2023, 12:02 PM

9. 
   tikka6.5 liked post by Pommy On thread : 6.5 staball vs 2209

   You should be able to use StaBall to drive a 130-143gr bullet to at least the same velocity as you get with 2209. So yes it's a viable backup option in that sense. It might not be 42gr that does...

   Liked On: 04-09-2023, 10:37 PM

10. 
    zimmer liked post by Pommy On thread : Ptg reamers

    They are OK. Just a shit company to deal with sometimes.

    Liked On: 02-09-2023, 01:41 PM

11. 
    blip liked post by Pommy On thread : Ptg reamers

    They are OK. Just a shit company to deal with sometimes.

    Liked On: 02-09-2023, 01:13 PM

12. 
    Beetroot liked post by Pommy On thread : 6.5 Sherman Short Tactical

    Is it a proper short action with 2.860" mags? Or do you have enough room to stretch things out to 2.960"? Because 6.5 PRC would be so much simpler.

    Liked On: 27-08-2023, 05:54 PM

13. 
    TimC liked post by Pommy On thread : Silencer Thread - which is best???

    Yeah the diameter of the barrel is what matters. From a mechanical perspective, the best thread to use is the fattest one you can use that still gives a good shoulder for the suppressor to tighten up...

    Liked On: 26-08-2023, 03:09 PM

14. 
    Micky Duck liked post by Pommy On thread : Silencer Thread - which is best???

    Yeah the diameter of the barrel is what matters. From a mechanical perspective, the best thread to use is the fattest one you can use that still gives a good shoulder for the suppressor to tighten up...

    Liked On: 23-08-2023, 04:51 PM

15. 
    Fssprecision liked post by Pommy On thread : Silencer Thread - which is best???

    Yeah the diameter of the barrel is what matters. From a mechanical perspective, the best thread to use is the fattest one you can use that still gives a good shoulder for the suppressor to tighten up...

    Liked On: 23-08-2023, 03:34 AM

Page 11 of 79 First 1234567891011121314151617181920212223242561 ... Last

• Jump to page: