The B14 extreme hunter with 18” barrel is ceracote over stainless. Nice guns.
Liked On: 27-07-2020, 08:23 AM
I have the extreme hunter version and i am pretty sure they are stainless under the cerekote yes. Don't think the standard b14s are tho. I could be wrong.
Liked On: 27-07-2020, 08:23 AM
stevodog off to gizzy hopefully if it aint washed away Tahr suprised the 55gn,62gn didnt work in 1:9 the 75gn probably be worse????
Liked On: 17-07-2020, 02:31 PM
DoC's lemon sucking attitude that no non native flora and fauna should exist in national parks is grossly bigoted nonesence IMHO because if their fanatical stupidy was carried through "broadbrush"...
Liked On: 09-07-2020, 10:37 PM
If you’re going to buy an old truck, buy a petrol. Hands down the best option is a 1GR-FE V6 4.0 engined Prado, or even better for NZ use, the rare but findable Hilux with the same engine. The...
Liked On: 08-07-2020, 02:32 PM
Funnilly enough I though that a gunsmith would be all of those things + a machinist.
Liked On: 08-07-2020, 12:15 PM
I would expect the supplier or gunsmith to stand by their work and make it right, especially if they’d supplied the parts.
Liked On: 08-07-2020, 12:15 PM
Yup need to get it out acquire some rust spots and bruises...:)
Liked On: 07-07-2020, 01:27 PM
144439144440144441144442144443[ATTACH]
Liked On: 07-07-2020, 01:12 PM
Fox River FX-529CB. Nice cherry wood, N690Ca, very sharp from box and nice embossed sheath. 144382 144385
Liked On: 06-07-2020, 08:02 PM
belts are the one thing you need to treat like they are free but fuck its hard:)
Liked On: 06-07-2020, 04:39 PM
I Look for a stick with a hand natural grip shape on the trunk. The Kanuka might be 4mtr or so tall and just the centre section is cut out. Don't scrape the inner bark off the stick - that will...
Liked On: 06-07-2020, 10:23 AM
A proper mustering stick is a light manuka or Kanuka pole cut to a length so that the thumb knuckle of you grip hand is at the same height as your nipple when gripping the stick and standing up...
Liked On: 06-07-2020, 08:34 AM
143918 About there somewhere
Liked On: 04-07-2020, 02:24 PM
those arent flat......well only a little... so what I do when setting up dies..as per OLD Nosler manual is to set up the full length die as per normal BUT instead of screwing it DOWN the extra turn...
Liked On: 04-07-2020, 11:38 AM