Pretty sure Dorkus wants to buy it
Liked On: 10-02-2020, 10:05 AM
My limited experience with them in my 7mm08 has been good. Got them going 2800 in my tikka with RE17. Do have a LA mag and bolt stop as they didn't shoot at mag length with original magazine. ...
Liked On: 10-02-2020, 09:56 AM
I have a couple of old bow saws that I would be happy to give away, no one here uses them...the last time I flew into the bush we took a sabre saw and several batteries so as not to break the no...
Liked On: 09-02-2020, 09:11 PM
I would say it was quite possibly, plenty of fish and the odd large marine mammal like a seal which large mature whites are known to predate on. Yep there's Tiger sharks in NZ , Mayor Island's...
Liked On: 09-02-2020, 05:54 PM
+1 I use pork cheeks for fat and add 20% to the total mixture. Well seasoned with Salt and Pepper and that's it. People get carried away adding stuff imo when the whole point is to have a...
Liked On: 08-02-2020, 10:49 PM
Hey Ryan, you sold me a scope a while back eh? Im guessing you are from the south of the south? Man, for the opportunity to knock over a couple of critters id go for a drive and lend a hand for...
Liked On: 07-02-2020, 12:38 PM
Some might ream if you supply a reamer? Cheaper than a barrel plus you get a lighter profile typically from factory
Liked On: 31-01-2020, 09:46 AM
The Tikka's in 6.5cm come with an Med+ sized magazine which is longer than the normal Med/.308 etc sized magazine, which at least in my experience allowed for seating of 143ELDX to the lands and...
Liked On: 22-01-2020, 06:58 AM
Here are some before and after pics using the above method. Thought I'd give it a go. Was planning on parkerizing or some form of coating so should hopefully be invisible once finished. 128320 ...
Liked On: 16-01-2020, 07:26 PM
Another method much practiced in the US is to fill the hole with a screw (one that you know takes blue) of the correct thread and then gently preen the head to completely fill the hole. Correctly...
Liked On: 16-01-2020, 07:23 PM
had same issue backed die off 1/8 turn
Liked On: 16-01-2020, 02:20 PM
I like to screw it in bit by bit till the case just chambers nicely. Sent from my iPhone using Tapatalk
Liked On: 16-01-2020, 02:16 PM
someone who currently shoots recoilless .260 and has never shot anything bigger than a .308 SHOULD listen....at very least PLEASE try a few rounds through one of the bigger rifles you are looking...
Liked On: 15-01-2020, 09:58 PM
If you're looking at running a tikka then WSM makes sense, long bolt stop and mag and you can seat them out way further than your lands will allow anyhow
Liked On: 15-01-2020, 09:17 PM
Yup the bolt picks them up and cycles everything fine. I removed the guts of the magazine (spring and part that bullet sits on) then forced the steel lip up using a screwdriver and then pulled it out...
Liked On: 15-01-2020, 09:10 PM