I read that as coils of weed full stop for some reason...
To be fair I’m as pure as the day I was born, never tried any drugs that weren’t prescribed by my Doc! I’ve always seen it as a weekness, and am a little bit pedantic about what goes into my body! Saying that I smoked till I was 23 hahahaha
Boom, cough,cough,cough
Plenty of cannabis around in my younger days, alcohol was mainly draught beer, had the old bing on vodka, blackberry nip, but learnt hangovers were a pain in the arse when I was in my 30s. Hate being pissed, but enjoy wine, beer or a good whiskey, on a regular basis in small doses. If I keep talking like the I’ll be joining a church singing hallelujah and talking in tongues.
Boom, cough,cough,cough
Ever used methyl theobromine - aka caffeine? The most widely used recreational drug on the planet. Sold in every cafe and supermarket.
Old Knife, worn stamping Original Bowie Knife , Widdag Solingen Germany great steel easy hold an edge.
![]()
strangely enough my first sheath knife was an origonal bowie...made in japan....had same leather handle as one above...blade smaller than yours....
, an important knife for me this one. Last of the lock down knives I got finished. Stainless 14c28n stainless Mamba. Stabilized Rimu with lime green Juma snake skin handles. G10 liners and pin stock.
This is the last knife to come off my little 1 x 30 grinder.
It's nearly worn out now but has been a great little machine and I have learned a hell of a lot using it.
I now have my 2 x 72 grinder running so the level and learning go up again.
Hi team, just want to give a big shout out to @terryf from Knives4Africa, we made me a bespoke sheath for my Mora Kansbol, rapt with it, big thanks again Terry
![]()
While I might not be as good as I once was, Im as good once as I ever was!
Rule 4: Identify your target beyond all doubt
Scouser’s Bushcraft Knife Project Phase 3
The red G10 Liners arrived from @Shelley, big thanks mate, he also sent me some S/S pipe and brass rod for the rivets, I decided to make all 3 Stainless Steel….
So first was to open up the existing holes in the blank handle from 5mm to 8mm in my milling jig
Then turn the two S/Steel pins
Then score up the blade handle section with the Dremel to give the Epoxy glue a good chance to stick, and rough up both sides of the Liners……
![]()
While I might not be as good as I once was, Im as good once as I ever was!
Rule 4: Identify your target beyond all doubt
Haven't been doing any knifemaking lately, but started this little project tonight.
1x old set of sheep hand shears
1x spiker antler (right hand)
Just testing handle fit and balance before annealing the blade to straighten and remove the set, grind in the bevels, heat treat, fit the handle and sharpen.
Should make a cool little kitchen knife for hunting expeditions
![]()
What a brilliant idea to use the old shears, looking forward seeing the next steps to something truly innovative and kreative,
thanks for sharing !
Or you can stay within 300 yards and keep life a lot simpler.
Bookmarks